Honda Powered Pressure Washer
Pressure washers equipped with Honda engines are a good choice for home owners and professionals alike. Now that the quality of equipment has improved along with price reductions, many home owners have purchased their own pressure washers rather than renting them, and Honda-powered models are among the most popular. Yet like with all power equipment, things can go wrong. The majority of problems are readily identifiable and easily fixed.
Engine Will Not Start
Before starting your Honda-equipped pressure washer, make sure the intake water hose is connected and turned on. Release the trigger on the wand and run water through the machine until all air is purged from the system. Many pressure washers will not allow the engine to run if water is not free to move through the unit.
The most common problem with gas-powered equipment is trouble starting the engine. Check to ensure proper fuel has been added. If the fuel is more than 30 days old, it may need to be replaced.
Locate the fuel switch on the engine, and turn it to the on position. The fuel switch, choke and throttle lever are located on the engine opposite the water hose connections. If you're starting a cold engine, move the choke lever out to the midway point. Open the throttle to one-third. If the starter cord will not move after a couple of pulls, pull the trigger on the gun to release water pressure. Once the engine starts, return the choke to the off position after a few seconds.
On models with an oil alert system, the engine will not start if engine oil level is low. Check and fill if necessary.
If the engine still will not start and the smell of gas is present, close the choke valve and wait a few minutes, as the engine could be flooded. Try starting the engine again, this time with the choke off, and the throttle opened all the way. You may need to remove and dry the spark plug and try starting again. A fouled or improperly gapped spark plug could also be a problem, and should be replaced.
Engine Lacks Power
If the exhaust contains a lot of smoke, check to see if the choke is on and return it to the off position. If fuel is oxidized or has water present, replace with fresh fuel. Ensure there is an unrestricted air supply to the engine and that the air filter is clean. Other problems, such as carburetor or ignition malfunction or stuck valves, will require taking the unit to an authorized Honda dealer.
Low or No Water Pressure, Leaky Hose or Wand
Check to see if the water source is fully turned on, and if pressure is adequate. If leaks are spotted, tighten connections. If they persist, new O-rings or washers may be needed. Make sure all quick connects are tight and locked and that there are no crimps or bends in the hoses. Check to ensure the proper wand nozzle tip is locked in place and is clean and not worn or damaged. Follow the manufacturer's instructions when changing tips on the wand. Clean filter screens on the water intakes if they are clogged. If the water supply fails, turn off the engine until the problem is fixed.
Storage and Maintenance
Always follow all manufacturer-recommended maintenance, such as changing the engine and pump oil, and keep your unit clean to ensure easy starting and use. Store the unit in a clean, dry place to avoid getting water or debris in the fuel filter and air intake. Check the oil levels on the engine and pump before every use. After use, drain the water from the hoses and pressure washer, and disconnect the hoses and trigger gun.
Related Posts:
Pressure Wash Concrete Driveways
Ive been in the pressure washing business for over 6 years, Due to a location change Ive been out of work and ended up writing articles on pressure wash things.Today i will teach you Pressure Wash...
Shallow Well Pump Troubleshooting
Shallow wells are typically wells that are less than 40 feet deep. The pumps that service these types of wells can be either a single-pipe or a double-jet pump. The jet-type pump forces water back...
Repair A Maytag Front Loading Washer
Most of us take our home appliances for granted. They help us to shave countless hours off our list of daily chores, so when something happens to them, it's hard to imagine how we ever lived witho...
Replace The Fuel Pressure Regulator On A Duramax Lly
Duramax engines are eight-cylinder, 6.6-liter engines manufactured by General Motors. The LLY version was in production from 2004 to 2005, and is a common engine for full-size Chevrolet pickups. T...
Generac Generator Troubleshooting
Won't StartThere are a few issues that can develop with a Generac generator. The first is if it won't start at all. When this happens you should look to the fuel tank first to determine if it is o...
